GCoffey wrote:Afternoon.
Does eValid have a way to signal that a monitoring test was or wasn't successful?
Thanks
Good question thanks for posting GCoffey.
The environment in which eValid executes a monitoring test often needs to know "what happened" during tes execution.
eValid uses an "exit code" that is the composition of a number of signals that indicate operation matters.
You can see the error/exit codes here:
http://www.e-valid.com/Products/Documen ... codes.htmlNote that each bit of a decimal number is used to indicate a good/bad result for each of several different factors.
The bits are set in the error/exit code (the "return code") before exit, so in effect the error code is the SUM of the various bits.
There can be several error/exit conditions.
-- eValid Support